1: Programmer Key Functions; Mode Key; Lamp Test Key - Fire-Lite 411UD Manual

Normal Mode
The 411/411UD can be switched from Normal Mode to any other Mode, provided no channel pro-
grammed for fire alarm or fire supervisory is active, that is, in alarm (shorted). The PRO-411
DACT Programmer, for use with the Fire•Watch 411 Series, must be connected to the 411/411UD
in order to change from mode to mode.
3.1.1 Programmer Key Functions
Address entry keys are 0 to 9
Data entry keys are 0 to 9 and A to F

MODE KEY

Pressing the MODE key followed by a valid 4-digit numerical code and the [ENTER/STORE]
key selects one of the five modes of operation. To enter Normal Mode from any other mode, press
the MODE key followed by 6676 and then [ENTER/STORE].
• 6676 spells NORM on a Touch-Tone
If an incorrect key is entered, reenter the proper 4-digit code before pressing the [ENTER/STORE]
key. Note that as information is entered into the 411/411UD, the digits will scroll across the Pro-
grammer display from right to left.
A pause of up to 10 seconds between each number is allowed while entering the code.

LAMP TEST KEY

Pressing the Lamp Test key on the Programmer, while the digital communicator is in Normal
Mode, will cause the front panel LEDs and all segments of the four 7-segment display on the
411/411UD to light. Lamp Test works only in Normal Mode. Note that LED located on the circuit
board (Phone Line active LED) will not light (411UD).
411 & 411UD Manual — P/N LS10105-000GE-E:A 1/29/2014
Figure 3.1 Programmer Keypad
___6
__66
_667
6676
Select operating mode
Increment memory address
Decrement memory address
One press = first memory address
Two presses = type any address
Save data, go to next address
® phone.
Modes of Operation
23