Icom ID-51A Advanced Instructions page 113

Previous view
9
D-STAR OPERATION <ADVANCED>
Repeater list programming (Continued)
■
4. Repeater call sign programming
When used for simplex communication, go to
[7. Access repeater setting].
!7 Push D-pad( ) to select "CALL SIGN," and then

push D-pad(Ent) to enter the repeater call sign edit
mode.
D-pad
(Ent)
(�)
!8 Rotate [DIAL] to select the first character.
• A to Z, 0 to 9, / and a space can be selected.
• A space can be entered in any input mode selected.
• Push [CLR] to delete the selected character, or hold
down [CLR] to continuously delete the characters,
first to the right, and then to the left of the cursor.
!9 Push D-pad() to move the cursor to the second
digit.
@0 Repeat steps !8 and !9 to enter a name of up to 8
characters, including spaces.
@1 After entering the call sign, push D-pad(Ent).
Information
✓
Be sure to add a repeater node (port) letter as the 8th
digit in the call sign field after a repeater call sign, ac-
cording to the repeater frequency band, as shown be-
low.
Note that Japanese repeater node letters are different.
1200 MHz : A (B in Japan)
430 MHz : B (A in Japan)
144 MHz : C (no D-STAR repeaters in Japan)
Cross band operation between different nodes at the
same repeater site can be made.
9-26
Example:
"JP1YYY A" is
entered.
☞ Continued on the next page.