Setting The Measurement Area And Specular Component Mode - Konica Minolta CM-2600d Instruction Manual

Setting the Measurement Area and Specular Component Mode

2
Turn B to select the desired setting, then press A.
<Settings>
• M/I+E: Measurement area:ø8 mm, simultaneous measurement of SCI (Specular Component Includ-
ed) and SCE (Specular Component Excluded)
• M/SCI: Measurement area:ø8 mm, SCI (Specular Component Included)
• M/SCE:Measurement area:ø8 mm, SCE (Specular Component Excluded)
• S/I+E: Measurement area:ø3 mm, simultaneous measurement of SCI (Specular Component Includ-
ed) and SCE (Specular Component Excluded)
• S/SCI: Measurement area:ø3 mm, SCI (Specular Component Included)
• S/SCE: Measurement area:ø3 mm, SCE (Specular Component Excluded)
• The measurement area that suits the Target Mask used for measurement or the setting of the lens po-
sition selector switch must be selected.
• With the CM-2500d, only "M/
If the mask type has been changed
from "M/ *** " to "S/
versa, a message will appear when
A
is pressed, inform you that
the mask (measurement area) has
been changed. The next item will
then appear automatically.
*** " can be selected.
*** " or vice
Setting a Measurement Condition
E-35