Ricoh SP 5310DN User Manual page 83

Message
"Rplcmnt Rqrd Soon:Drum
Unit"
"SD Card
authenticatn.failed Error
recurs, call service."
"Set the Drum Unit
correctly."
"Set the Maintenance Kit
correctly."
"Set the Toner Cartridge
correctly."
"Standard Tray is full.
Remove the paper."
"Supply order has failed."
"This NetBIOS name is
already in use.(108/208)"
"The same IPv4 Address
already exists.(102/202)"
"The selected job has
already been printed or
deleted."
"USB has a problem. Please
call service."
"Values set for IPv6/
Gateway addresses are
invalid.(110/210)"
Cause
You will need to replace the drum
unit soon.
Authentication from the SD card
failed.
The drum unit may not be installed
correctly.
The fusing unit may have not been
installed correctly.
The print cartridge may have not
been installed correctly.
The standard tray is full.
The automatic supply order failed. The message indicates the printer
The NetBIOS name specified for
the printer is already used by
another device on the network.
The IPv4 address specified for the
printer is already used by another
device on the network.
This message might appear if you
print or delete a job from Web
Image Monitor.
The printer has detected a USB
board failure.
The IPv6 address or gateway
address is invalid.
When Messages Are Displayed
Solution
Contact your sales or service
representative to obtain a new
unit.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
Contact your sales or service
representative.
Contact your sales or service
representative.
Turn the printer off, and install the
print cartridge again.
Remove the paper.
tried to order the supplies.
Contact your network
administrator.
Contact your network
administrator.
Press Exit on the message screen.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
Check the network settings.
81