Verifying The Configuration - HP 5500 EI Series Configuration Manual

Figure 51 Network diagram
Configuration procedure
1. Assign each interface an IP address. (Details not shown.)
2. Configure a static route, whose destination address is 10.2.1.1, and associate the static route with
track entry 1 on Device A.
<DeviceA> system-view
[DeviceA] ip route-static 10.1.1.2 24 10.2.1.1 track 1
3. On Device A, create an NQA test group:
# Create an NQA test group with the administrator name being admin and operation tag being
test.
[DeviceA] nqa entry admin test
# Configure the test type of the NQA test group as ICMP echo.
[DeviceA-nqa-admin-test] type icmp-echo
# Configure ICMP echo requests to use 10.2.1.1 as their destination IP address.
[DeviceA-nqa-admin-test-icmp-echo] destination ip 10.2.1.1
# Configure the device to perform tests at an interval of 100 milliseconds.
[DeviceA-nqa-admin-test-icmp-echo] frequency 100
# Create reaction entry 1. If the number of consecutive probe failures reaches 5, collaboration
with other modules is triggered.
[DeviceA-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail
threshold-type consecutive 5 action-type trigger-only
[DeviceA-nqa-admin-test-icmp-echo] quit
# Configure the test start time and test duration for the test group.
[DeviceA] nqa schedule admin test start-time now lifetime forever
4. Create track entry 1 on Device A, and associate it with reaction entry 1 of the NQA test group
(admin-test).
[DeviceA] track 1 nqa entry admin test reaction 1

Verifying the configuration

# On Device A, display information about all track entries.
[DeviceA] display track all
Track ID: 1
155