Configuring Layer 2 remote port mirroring
Layer 2 remote port mirroring configuration task list
Configuring Layer 2 remote port mirroring is to configure remote mirroring groups. To do that, configure
the remote source group on the source device and configure the cooperating remote destination group
on the destination device. If an intermediate device exists, allow the remote probe VLAN to pass through
the intermediate device.
NOTE:
HP recommends you not enable GARP VLAN Registration Protocol (GVRP). If GVRP is enabled, GVRP
may register the remote probe VLAN to unexpected ports, resulting in undesired duplicates. For more
information about GVRP, see
Configure the following on the source device:
Source ports
•
Remote probe VLAN
•
•
The egress port
Then, configure the following on the destination device:
Remote probe VLAN
•
Monitor port
•
Complete these tasks to configure Layer 2 remote port mirroring:
Task
Configuring a
remote destination
group
Configuring a
remote source group
Layer 2—LAN Switching Configuration Guide
Creating a remote destination group
Configuring the monitor port for the remote destination group
Configuring the remote probe VLAN for the remote destination
group
Assigning the monitor port to the remote probe VLAN
Creating a remote source group
Configuring source ports for the remote source group
Configuring the egress port for the remote source group
Configuring the remote probe VLAN for the remote source group
94
.
Remarks
Required.
Required.
Required.
Required.
Required.
Required.
Required.
Required.