HP 5500 EI Series Configuration Manual page 108

Step
2. Configure the egress port for
the remote source group.
To configure the egress port for the remote source group in interface view:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the current port as
the egress port.
NOTE:
A mirroring group contains only one egress port.
•
A source port of an existing mirroring group cannot be configured as an egress port.
•
Configuring the remote probe VLAN for the remote source group
Before configuring a remote probe VLAN, create a static VLAN that will serve as the remote probe VLAN
for the remote source group.
1. Configuration restrictions and guidelines:
A VLAN can serve for only one mirroring group.
When a VLAN is configured as a remote probe VLAN, you must remove the remote probe
VLAN configuration before deleting the VLAN.
When you remove the configuration of a remote probe VLAN, an active mirroring group
becomes inactive.
When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
mirroring exclusively. Do not create a VLAN interface for the VLAN or configure any other
features for the VLAN.
The remote mirroring groups on the source device and destination device must use the same
remote probe VLAN.
2. Configuration procedure:
To configure the remote probe VLAN for the remote source group:
Step
1. Enter system view.
2. Configure the
remote probe
VLAN.
Command
mirroring-group group-id
monitor-egress
monitor-egress-port
Command
system-view
interface interface-type
interface-number
mirroring-group group-id
monitor-egress
Command
system-view
mirroring-group group-id
remote-probe vlan
rprobe-vlan-id
98
Remarks
By default, no egress port is configured for
a remote source group.
Remarks
N/A
N/A
By default, a port does not serve as the
egress port for any remote source group.
Remarks
N/A
By default, no remote probe VLAN is configured
for a remote source group.