Configuring Snmp Tests - HP 5500 EI Series Configuration Manual

Step
6. Specify the source port
number of UDP packets.
7. Configure the size of the data
field in each UDP packet.
8. Configure the string to be
filled in the data field of each
probe packet.
9. Configure the number of
probe packets to be sent
during each UDP jitter probe
operation.
10. Configure the interval for
sending probe packets during
each UDP jitter probe
operation.
11. Configure the interval the
NQA client must wait for a
response from the server
before it regards the response
is timed out.
12. Configure the source IP
address for UDP jitter packets.
13. Configure optional
parameters.
NOTE:
The probe count command specifies the number of probe operations during one UDP jitter test. The probe
packet-number command specifies the number of probe packets sent in each UDP jitter probe operation.

Configuring SNMP tests

SNMP tests of an NQA test group are used to test the time the NQA client takes to send an SNMP packet
to the SNMP agent and receive a response.
Before you start SNMP tests, enable the SNMP agent function on the device that serves as an SNMP
agent. For more information about SNMP agent configuration, see
To configure SNMP tests:
Command
source port port-number
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
source ip ip-address
See "Configuring
optional parameters for
an NQA test group"
124
Remarks
Optional.
By default, no source port number is
specified.
Optional.
100 bytes by default.
Optional.
By default, the string is the hexadecimal
number 00010203040506070809.
Optional.
10 by default.
Optional.
20 milliseconds by default.
Optional.
3000 milliseconds by default.
Optional.
By default, no source IP address is specified.
The source IP address must be the IP address
of a local interface. The local interface must
be up. Otherwise, no probe packets can be
sent out.
Optional.
"Configuring SNMP."