Configuring The Dns Server; Configuring Acs And Cpe Attributes Through Acs; Configuring Cwmp At The Cli - HP 5500 EI Series Configuration Manual

• 27 indicates that the length of the subsequent hexadecimal strings is 39 characters.
68747470 3A2F2F31 36392E32 35342E37 362E3331 3A373534 372F6163 73 corresponds to
•
the ACS address http://169.254.76.31/acs.
3132 3334 corresponds to the username 1234.
•
35 3637 38 corresponds to the password 5678.
•
20 is the end delimiter.
•
For more information about DHCP, DHCP Option 43, the option command, DHCP address pool
configuration, and DNS server configuration, see Layer 3—IP Services Configuration Guide.

Configuring the DNS server

On the DNS server, you need to bind the URL address to the IP address of the ACS server to make sure
CPEs can obtain the IP address of the ACS through the DNS function.

Configuring ACS and CPE attributes through ACS

An ACS performs autoconfiguration of a CPE through remote management. For the primary configurable
parameters, see
user manual came with your ACS server.

Configuring CWMP at the CLI

You can set CWMP parameters at the CLI.
The switches operate as CPEs in a CWMP-enabled network, so the following describes only the
configuration on CPEs.
Complete these tasks to configure CWMP:
Task
Enabling CWMP
Configuring the ACS server:
•
Configuring the ACS URL
•
Configuring the ACS username and password
Configuring CPE attributes:
•
Configuring the CPE username and password
•
Configuring the CWMP connection interface
•
Configuring the maximum number of attempts made to retry a connection
•
Configuring the close-wait timer of the CPE
•
Configuring the CPE working mode
"Configuration parameter deployment." For how to configure the ACS server, see the
209
Remarks
Required.
Required.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.