Alarm Group Configuration Example - HP 5500 EI Series Configuration Manual

dropevents
packets
multicast packets : 6
undersize packets : 0
fragments
collisions
Sampled values of record 8 :
dropevents
packets
multicast packets : 6
undersize packets : 0
fragments
collisions
# On the configuration terminal, get the traffic statistics through SNMP. (Details not shown.)

Alarm group configuration example

Network requirements
Configure the RMON alarm group on the RMON agent in
five-second incoming traffic statistic on GigabitEthernet 1/0/1 crosses the rising threshold or drops
below the falling threshold.
Figure 31 Network diagram
Configuration procedure
# Configure the SNMP agent with the same SNMP settings as the NMS at 1.1.1.2. This example uses
SNMPv1, read community public, and write community private.
<Sysname> system-view
[Sysname] snmp-agent
[Sysname] snmp-agent community read public
[Sysname] snmp-agent community write private
[Sysname] snmp-agent sys-info version v1
[Sysname] snmp-agent trap enable
[Sysname] snmp-agent target-host trap address udp-domain 1.1.1.2 params securityname
public
# Configure the RMON statistics group to gather traffic statistics for GigabitEthernet 1/0/1.
[Sysname] interface gigabitethernet 1/0/1
: 0 , octets
: 7 , broadcast packets
, CRC alignment errors : 0
, oversize packets
: 0 , jabbers
: 0 , utilization
: 0 , octets
: 13 , broadcast packets
, CRC alignment errors : 0
, oversize packets
: 0 , jabbers
: 0 , utilization
85
: 766
: 0
: 0
: 0
: 0
: 1154
: 1
: 0
: 0
: 0
Figure 31 to send alarms in traps when the