Setting Fence Stops - Grizzly G0490W Owner's Manual

Setting Fence Stops

The fence stops simplify the task of adjusting the
fence to 45° inward, 90°, and 45° outward (135°).
Tools Needed
45° Square ........................................................ 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Wrench 10mm ................................................... 1
Hex Wrench 5mm .............................................. 1
Setting 45° Inward Fence Stop
1.
DISCONNECT MACHINE FROM POWER!
2. Pull out and lock tilt plunger (see Figure 83),
loosen fence tilt lock and fence lock, then tilt
fence approximately 45° inward onto stop
cap screw.
45° Inward
Stop Cap
Screw
Figure 83. 45° inward positive stop cap screw.
3.
Place 45° square against fence and table,
(see Figure 84).
Figure 84. Fence adjusted to 45 ° inward.
4. Loosen jam nut shown in Figure 83.
5.
Adjust stop cap screw until fence is exactly
45° inward while resting on screw (verify
angle with a 45° square), retighten jam nut,
tilt lock, and fence lock.
-48-
Qty
Tilt Lock
Tilt
Plunger
Jam Nut
Setting 90° Fence Stop
1.
DISCONNECT MACHINE FROM POWER!
2.
Pull out and lock tilt plunger and loosen fence
tilt lock (see Figure 85).
Plunger
Tilt Lock
Indicator
Figure 85. Adjusting fence to 90 ° .
3. Using a 90° square, adjust fence to 90° posi-
tion (see Figure 85), then unlock plunger. It
should insert into indexing ring and lock fence
at 90° position.
4. Adjust indicator (if necessary) to 0° to cali-
brate fence tilt scale.
Setting 45° Outward Fence Stop
1.
DISCONNECT MACHINE FROM POWER!
2. Pull out and lock tilt plunger (see Figure 83),
loosen fence tilt lock and fence lock, then tilt
fence against 45° outward stop bolt.
3. Loosen jam nut shown in Figure 86.
Tilt
Plunger
Jam Nut
Figure 86. Fence adjusted 45˚ outward.
4.
Adjust 45° outward stop bolt until fence is
exactly 45° outward while resting on bolt
(check angle with sliding bevel set to 135°),
then retighten jam and tilt lock.
Model G0490W/G0490XW (Mfd. Since 5/16)
Indexing
Ring
Fence Tilt
Scale
45° Outward
Stop Bolt
Tilt Lock