Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Inventory (Figures 8–10):
A. Jointer Assembly ........................................ 1
B. Fence and Carriage Assembly ................... 1
C. Push Blocks ................................................ 2
D. Service Tools:
— Open-End Wrench 8/10mm .................... 1
— Open-End Wrench 11/13mm ................... 1
—Hex Wrenches 3, 4, 5, 6, 8mm ..........1 Ea
E. Fence Tilt Handle ....................................... 1
F.
Fence Lock Lever ....................................... 1
G. Cutterhead Guard ....................................... 1
H. Cabinet Stand w/Motor ............................... 1
I.
Control Panel Pedestal Assembly .............. 1
J.
Dust Port .................................................... 1
K. Belt ............................................................. 1
L. Belt Guard .................................................. 1
M. Pedal Assembly .......................................... 1
N. Knife-Setting Jig (G0490W)
—External Retaining Rings 10mm ......... 2
—Knife Jig Feet ...................................... 2
—Knife Jig Rod ....................................... 1
O. Cutterhead Hardware & Tools (G0490XW)
—Driver Bit Torx T20 .............................. 1
—L-Wrench Torx T20 .............................. 1
—Flat Hd Torx Screws T20 M6-1 x 15 ... 5
—Indexable Inserts 14 x 14 x 2mm ........ 5
Hardware Bag (Not Shown):
•
Cap Screws M8-1.25 x 50 (Wheel/Stand) .. 3
•
Flat Washers 8mm (Wheel/Stand) ............. 6
•
Lock Washers 8mm (Wheel/Stand) ........... 3
•
Hex Nuts M8-1.25 (Wheel/Stand) ............... 3
•
Phillips Hd Screws M5-.8 x 10 (Dust Port) . 4
•
Flat Washers 5mm (Dust Port) ................... 4
•
Cap Screws M8-1.25 x 20 (Jointer/Stand) .. 8
•
Lock Washers 8mm (Jointer/Stand) ........... 8
•
Flat Washers 8mm (Jointer/Stand) ............. 8
•
Flange Bolts M6-1 x 12 (Belt Guard) .......... 2
-16-
C
Qty
Figure 8. G0490W/G0490XW inventory—box 1.
Figure 9. G0490W/G0490XW inventory—box 2.
N
(G0490W Only)
Figure 10. Miscellaneous inventory items.
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0490W/G0490XW (Mfd. Since 5/16)
A
B
E
F
D
H
K
L
J
O
(G0490XW Only)
NOTICE
G
I
M
Advertisement
Table of Contents
