Grizzly G0490W Owner's Manual page 23

12. Loosen fence lock lever and fence tilt lock,
make sure fence is at 90° position, then move
fence all the way forward to verify it is aligned
with front edge of tables (see Figure 22).
— If fence is aligned with front of tables, con-
tinue to Step 14.
— If fence is not aligned with front of tables,
continue to Step 13.
Fence
Lock Lever
Figure 22. Fence moved to front of tables to
check alignment.
13. Loosen (3) M6-1 x 12 cap screws that secure
fence key, as shown in Figures 23–24,
adjust fence side to side until it is aligned with
front of tables, then tighten cap screws.
Figure 23. Loosening front cap screw on key.
Figure 24. Loosening rear cap screw on key.
Model G0490W/G0490XW (Mfd. Since 5/16)
Fence Tilt
Lock
Tables
Key
14. Install belt on cutterhead and motor pulleys,
as shown in Figure 25, making sure belt is
seated in pulley grooves.
Figure 25. Example of belt installed on
cutterhead and motor pulleys.
15. Loosen four bolts/nuts securing motor mount
brackets (see Figure 26), let motor slide
down to tension belt, then retighten bolts/
nuts.
Figure 26. Motor mount bracket bolts.
-21-