Grizzly G0490W Owner's Manual page 25

Belt guard MUST be installed before oper-
ating jointer or else moving belt will be
exposed, creating an entanglement hazard
at back of jointer.
18. Install belt guard with (2) M6-1 x 12 flange
bolts, as shown in Figure 31.
Belt
Guard
Figure 31. Belt guard installed.
19. Re-install cabinet rear access panel.
20. Move fence all the way back to make room
for cutterhead guard.
21. Insert cutterhead guard shaft into jointer,
as shown in Figure 32, so shaft flat is fac-
ing set screw, then tighten pre-installed set
screw against shaft. Position the bottom of
the guard so it is no more than
table, to ensure safety during operations.
Figure 32. Tightening set screw to secure
cutterhead guard.
Model G0490W/G0490XW (Mfd. Since 5/16)
22. Test operation of guard by pulling it back and
23. Install rabbeting table with (2) pre-installed
x 2
24. Model G0490W Only: Assemble knife-set-
⁄ " above the
3
8
letting go. Guard should spring back over
cutterhead and stop against the fence.
— If guard drags across table, loosen set
screw, raise guard slightly so that it does
not drag, then retighten set screw.
— If guard does not spring back over
cutterhead, re-install it and make sure flat
part of guard shaft faces set screw.
M8-1.25 x 20 cap screws and (2) 8mm lock
washers (see Figure 21).
Rabbeting
Table
Figure 33. Rabbeting table installed.
ting jig, as shown in Figure 34.
Figure 34. Knife-setting jig assembled.
x 2
-23-