Grizzly G0490W Owner's Manual page 22

8. Attach jointer assembly to stand with (8)
M8-1.25 x 20 cap screws, (8) 8mm lock
washers, and (8) 8mm flat washers, as
shown in Figure 17.
Figure 17. Jointer assembly attached to stand.
9.
Attach control panel pedestal to back of
infeed table with (2) pre-installed M10-1.5 x
20 cap screws and (2) 10mm flat washers
(see Figure 18).
x 2
Figure 18. Attaching control panel pedestal to
back of infeed table.
10. Verify alignment of cutterhead and motor pul-
leys, as illustrated in Figure 19.
Figure 19. Example of pulleys aligned.
-20-
x 8
Cutterhead
Pulley
Alignment
Motor
Pulley
— If pulleys are not aligned, loosen four
motor mounting bolts shown in Figure 20,
shift motor horizontally to align pulleys,
then retighten bolts.
Figure 20. Location of motor mount bolts.
11. Use (2) pre-installed M10-1.5 x 30 cap
screws, (2) 10mm lock washers, and (2)
10mm flat washers to attach fence carriage
base with fence onto rear of jointer assembly,
as shown in Figure 21, and Install fence lock
lever.
Fence Lock Lever
x 2
Figure 21. Fence assembly and carriage
installed.
Model G0490W/G0490XW (Mfd. Since 5/16)
Motor
Mount
Bolts
Fence
Fence
Carriage
Base