Grizzly G0490W Owner's Manual page 7

I
Figure 3. Cutterhead guard and depth-of-cut
scale.
I. Cutterhead Guard: Covers cutterhead
until pushed out of the way by workpiece
during operation. When workpiece leaves
cutterhead, guard springs back to its starting
position.
J. Depth-of-Cut Scale: Indicates depth of cut.
K
Figure 4. Location of positive stops.
K. Infeed Positive Stop Bolts: Control top and
bottom range of infeed table movement.
L. Outfeed Positive Stop Bolts: Tighten to
prevent outfeed table movement; loosen to
allow vertical movement of outfeed table.
Model G0490W/G0490XW (Mfd. Since 5/16)
J
L
Fence Controls
Figure 5. Location of fence controls.
M. Fence Tilt Stops: Stop fence at 45° inward
and 45° outward (135°).
Note: Even when fence is resting against
stops, fence tilt lock must be tightened before
starting machine.
N. Tilt Plunger: When engaged, sets fence at
90°. When disengaged, allows bevel cuts
greater than 90°.
O. Fence Tilt Lock: Secures fence at any posi-
tion in available range.
P
Q
Figure 6. Fence tilt handle and table locks.
P. Fence Tilt Handle: Tilts fence throughout its
range of motion from 45° inward to 45° out-
ward (135°).
Q. Fence Lock Lever: Tightens to secure fence
position along width of tables; loosens to
allow lateral adjustment.
O
N
M
-5-