Grizzly G0490W Owner's Manual page 24

Note: When properly tensioned, belt has
approximately ⁄ " deflection when moderate
1
4
pressure is applied midway between the pul-
leys, as illustrated in Figure 27. If necessary,
apply downward pressure on motor before
securing motor mount brackets to attain
proper belt tension.
Cutterhead Pulley
Approximately
/ " Deflection
1
4
Motor Pulley
Figure 27. Correct belt deflection when properly
tensioned.
16. Install fence tilt handle, as shown in Figure 28.
Figure 28. Fence tilt handle installed on rear of
fence.
The outfeed table MUST be level with
cutterhead knives or inserts when they are
at top dead center (at their highest point
during rotation). Otherwise, the workpiece
cannot properly feed past the cutterhead,
which may cause a kickback hazard for the
operator.
-22-
Tilt Handle
17. Place straightedge on outfeed table so it
extends over cutterhead, and use cutterhead
pulley to rotate cutterhead until one of the
knives or inserts is at top dead center (their
highest point during rotation), as illustrated in
Figures 29–30.
Top Dead
Center
Figure 29. Knife or insert at top dead center.
Straightedge
Outfeed
Bottom Dead
Straightedge
Center
Outfeed
Figure 30. Using straightedge to check outfeed
table height.
When outfeed table height is correctly set,
knife or insert (at top dead center) will barely
touch straightedge, as illustrated in Figure
30.
— If knife or insert lifts straightedge off table
or is below straightedge, then outfeed
table height must be reset (refer to Setting
Outfeed Table Height on Page 46 for
detailed instructions).
Model G0490W/G0490XW (Mfd. Since 5/16)
G0490W
G0490XW
Top Dead
Center
G0490W
Infeed
G0490XW
Infeed