Grizzly G0490W Owner's Manual page 45

Checking Infeed Table
1.
Follow all steps for checking outfeed table
parallelism to first make sure that outfeed
table is parallel with cutterhead.
2.
Correctly adjust outfeed table height (refer to
Setting Outfeed Table Height on Page 46
for detailed instructions).
3. Rotate cutterhead so knives/inserts will not
interfere, then place straightedge on infeed
and outfeed tables and adjust infeed table
even with outfeed table, as shown in Figure
70.
Straightedge
Outfeed Table
Figure 70. Infeed and outfeed tables set evenly
(knife-style cutterhead shown).
Model G0490W/G0490XW (Mfd. Since 5/16)
4.
Figure 71. Straightedge positions for checking
Infeed Table
Place straightedge in the positions shown
in Figure 71. In each position, straightedge
should sit flat against both outfeed table and
infeed table.
Black Lines Represent
Straightedge Positions
from Overhead View
infeed/outfeed table parallelism.
— If straightedge sits flat against both
infeed and outfeed tables in all positions
above, then tables are parallel. Replace
cutterhead guard, fence, and cabinet rear
access panel.
— If straightedge does not sit flat against
both infeed and outfeed tables in any of
positions, then follow Adjusting Table
Parallelism instructions on next page.
-43-