Table of Contents
Advertisement
3.
Place straightedge in one of the positions
shown in Figure 74, and adjust eccentric
bushings so straightedge touches cutterhead
body while lying flat across outfeed table (a
pin-type spanner wrench or small hammer
and punch may be necessary to turn eccen-
tric bushings).
Black Lines Represent
Straightedge Positions
From Overhead View
Figure 74. Straightedge positions for verifying if
outfeed table is parallel with cutterhead.
4.
Repeat Step 3 with each remaining straight-
edge position as many times as necessary
until outfeed table is parallel with cutterhead.
5.
Tighten/replace set screws in eccentric bush-
ings on outfeed table.
6.
Remove set screw from each of the four
eccentric bushings under infeed table.
7.
Place straightedge halfway across infeed and
outfeed tables, and adjust infeed table even
with outfeed table, as shown in Figure 75.
Straightedge
Outfeed Table
Figure 75. Infeed and outfeed tables set evenly
(knife-style cutterhead shown).
Model G0490W/G0490XW (Mfd. Since 5/16)
8.
Figure 76. Straightedge positions for checking
9.
10. Tighten/replace set screws in eccentric bush-
11. Perform Setting Outfeed Table Height on
Infeed Table
Place straightedge in one of the positions
shown in Figure 76, and adjust eccentric
bushings under infeed table so straightedge
lies flat against both tables.
Black Lines Represent
Straightedge Positions
from Overhead View
infeed/outfeed table parallelism.
Repeat Step 8 with each remaining straight-
edge position as many times as necessary
until infeed table is parallel with outfeed table.
ings on infeed table.
next page.
-45-
Advertisement
Table of Contents
