Setting Fence Stops - Grizzly EXTREME Series Owner's Manual

Setting Fence Stops

The fence stops simplify the task of setting the
fence to 90° and 45° (135°).
Models G9860 & G9860ZX
Tools Needed
Machinist's Square ............................................ 1
Bevel Square ..................................................... 1
Hex Wrench 3mm .............................................. 1
Wrench 10mm ................................................... 1
To set the 90° fence stop:
DISCONNECT JOINTER FROM POWER!
1.
Loosen the fence tilt lock and the jam nut on
2.
the 90° stop, then back off the set screw (see
Figure 64).
Tilt Lock
45° Stop
Figure 64. Fence stop controls.
-42-
Qty
90° Stop
Place the machinist's square flat on the
3.
outfeed table fairly close to the cutterhead,
as shown in Figure 65, adjust the fence to
the square, then tighten the fence tilt lock to
secure the setting.
Figure 65. Setting the fence to 90° (cutterhead
guard moved away for clarity).
Adjust the 90° set screw until it just touches
4.
the tilting arm, then re-tighten the jam nut.
To set the 45° fence stop:
DISCONNECT JOINTER FROM POWER!
1.
Loosen the fence tilt lock and the jam nut on
2.
the 45° stop, then back off the set screw (see
Figure 64 on the previous page).
Place the bevel square set at 135° flat against
3.
the outfeed table close to the cutterhead, as
shown in Figure 66, adjust the fence to
match the angled face of the square, then re-
tighten the tilt lock.
Figure 66. Setting the fence to 45° (135°), with
the cutterhead guard removed for clarity.
Adjust the 45° set screw until it just touches
4.
the tilting arm, then re-tighten the jam nut.
Extreme Series Jointer (Mfd. Since 10/20)