Toshiba RemotEye II User Manual page 63

RemotEye II Configuration
This page allows the administrator to set the RemotEye II local network configuration parameters. Within
the parameters, the Primary Time Server and the Secondary Time Server can only send out the correct
time information to a client that has the Shutdown program installed.
RemotEye II IP Address
This field allows the administrator to set the IP address of the RemotEye II or to view the current setting
(i.e., 192.9.60.229).
RemotEye II Gateway Address
This field allows the administrator to set the IP address of the gateway or to view the current setting (i.e.,
192.9.60.10).
RemotEye II Network Mask
This field allows the administrator to set the subnet mask of the RemotEye II or to view the current setting
(i.e., 255.255.255.0).
System Name
This field allows the administrator to set the value in System name that is defined in MIB-II or to view the
current setting. This string also serves as the RemotEye II Client Identifier (CID) in DHCP systems.
System Contact
This field allows the administrator to set the value in System manager (System Contact) that is defined in
MIB-II or to view the current setting.
NOTE: System will label each event email with the system Name and Location, in the format:
systemName@SystemLocation
System Location
This field allows the administrator to set the value in System installation place (System Location) that is
defined in MIB-II or to view the current setting.
History Log Interval
This field allows the administrator to set the polling time (in seconds) of the Input Voltage, Output Voltage,
Output Load, Battery Voltage, Input Frequency, and the UPS Output Source. The readings will be stored
in the history log.
Extended Log Interval
This field allows the administrator to set the consolidation interval (in minutes) to use in the creation of the
extended history log. The UPS parameters will be consolidated to provide the minimum, maximum, and
average values of the parameters that will be recorded in the extended history log.
RemotEye II Polling Rate
This field allows the administrator to set the time interval of the RemotEye II updates that are received
from the UPS.
RemotEye II Baud Rate
This field shows the data transmission rate between the UPS and the RemotEye II.
Default Language
This field allows the administrator to set the default language: English or Japanese. The RemotEye II
homepage will be displayed using the language set in the internet browser. If the language is not
supported by the RemotEye II, the RemotEye II will respond with the default language.
62 RemotEye II User Manual – 50024-014