Configuring The Remoteye Ii Via Telnet - Toshiba RemotEye II User Manual

Configuring the RemotEye II via Telnet

The RemotEye II can be configured by establishing a telnet session with the device.
Hardware Setup
Telnet configuration is accomplished through a network link. Follow these steps to setup the hardware for
telnet RemotEye II configuration:
Verify network cable connection to NETWORK port of RemotEye II.
Verify active link to LAN or Network.
For further information on the network connection, refer to Making the Network Connection on page 19.
Software Setup
The telnet configuration is accomplished through a TCP/IP network connection. A telnet connection can
be established with RemotEye II by using any telnet application. Follow these steps to setup the software
for telnet RemotEye II configuration:
Verify workstation is loaded with Telnet application.
Verify a valid network path exists between the RemotEye II and the workstation. If performing the telnet
configuration from a workstation that is located on the same network, then proceed to the next section to
the section, Connecting to the RemotEye II via Telnet on page 40, otherwise, continue with the next
section Routing to the RemotEye II on page 39.
38 RemotEye II User Manual – 50024-014