Warning System - Panasonic P2HD VariCam AJ-HPX3700G Operating Instructions Manual

Warning Description Tables
If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING
lamp, lamps inside the viewfinder and a warning tone.
Note
The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors
occur simultaneously a higher priority indication will be triggered. The [WIRELESS-RF], however, may not be indicated,
depending on the menu setting.
1. System Errors
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning description
Recording/playback
operation
Countermeasures
2. Card removal error
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning description
Recording/playback
operation
Countermeasures
3. Battery Empty
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning description
Recording/playback
operation
Countermeasures
160
Maintenance and Inspections: Warning System

Warning System

The error code lights up.
Blinks 4 times per second.
Blinks 4 times per second.
The "SYSTEM ERROR" indication and
the error code light up.
Beeps continuously.
An error in the reference signal or the
communication.
The operation stops.
Please confirm [Error Codes] (page 163)
and consult your distributor.
Error code "E-30" blinks.
Blinks 4 times per second.
Blinks 4 times per second.
The "TURN POWER OFF" indicator lights
up.
Continues to beep.
The P2 card being accessed has been
removed, resulting in an error in the
internal memory of the unit.
Cannot be performed.
Turn off the power to the unit. If there is
an error in a clip on the removed P2 card,
repair the clip.
All 7 bar indicators for battery remaining
capacity start blinking.
Lights up.
Blinks once per second.
The BATT LED lights up.
Beeps continuously.
The battery has run out.
The operation stops.
Replace the battery.
4. P2 Card Fully Recorded
Display window All 7 bar indicators for remaining MEDIA
indication capacity start blinking.
This lamp will illuminate continuously until
WARNING lamp
an operation is made after recording.
This lamp will flash 4 times every second
Tally lamp
until an operation is made after recording.
The "END" indicator blinks.
Viewfinder When a write protected P2 card has been
inserted, the "WP" indicator lights up.
This tone will sound continuously until an
Warning tone
operation is made after recording.
The P2 cards are recorded to maximum
Warning description
capacity.
Recording/playback
The recording stops.
operation
Delete the clips in the P2 card or insert a
Countermeasures
new P2 card.
5. Image Sequence Error (24P, 30P, 25P)
Display window "E-40" appears in the time code display
indication field.
WARNING lamp Blinks 4 times per second.
Blinks 4 times per second while recording
Tally lamp
continues.
Viewfinder The "REC WARNING" indicator lights up.
Beeps 4 times per second while recording
Warning tone
continues.
There are abnormal conditions in the
Warning description image sequence of the 24P, 30P, or 25P
mode.
Images can be recorded and played
Recording/playback
back, but some frames may be dropped
operation
or the sequences of TC and UB may shift.
Confirm the recording/playback operation
after turning off the power supply once
Countermeasures and then turning it on again. If the error is
not corrected after executing this
procedure, contact the dealer.