Panasonic P2HD VariCam AJ-HPX3700G Operating Instructions Manual page 94

6
Turn the jog dial button until a desired character
appears.
The characters that appear are switched in the following
order:
Space:
Alphabetical characters:
Numerals:
Symbols:
7
Press the jog dial button to accept a desired character.
8
Turn the jog dial button to move the arrow (cursor) to the
next digit (clockwise), and repeat steps 6 - 7 to set
characters (up to 8 characters).
To write data on a selected file
9
When the title is set, turn the jog dial button to move the
arrow (cursor) to : .

10
Press the jog dial button to return the arrow (cursor) to
the option TITLE.
11
Turn the jog dial button to move the arrow (cursor) to the
option WRITE.
12
Press the jog dial button to display the following
message:

94
Adjustments and Settings for Recording: Handling data
A to Z
0 to 9
', >, <, /, -
The data will not be written if any of the following messages
appears when the jog dial button is pressed:
Error message
WRITE NG
NO CARD
(No SD memory card inserted.)
WRITE NG
FORMAT ERROR
(SD memory card not properly
formatted.)
WRITE NG
ERROR
(SD memory card not writable.)
WRITE NG
WRITE PROTECT
(SD memory card write-
protected.)
WRITE NG
CANNOT ACCESS
(SD memory card not
accessible.)
WRITE NG
CARD FULL
(SD memory card has no free
space.)
13
Turn the jog dial button to move the arrow (cursor) to
YES. Then, press the dial button.
When the data has been written, the following message
appears:
14
To exit the menu, press the MENU button.
The settings menu disappears and the status of the unit
is indicated at the top and bottom of the viewfinder
screen.
Notes
The <SD CARD R/W SELECT> screen can be used to
select the type of the menu to be written on the SD
memory card.
It is possible to overwrite a setup file stored by a different
device with a new setup file from this unit. Note that if the
file is overwritten, the original setup file from the other
device will be lost.
We recommend managing the respective SD memory
cards on the respective devices independently.
Remedy
Insert an SD memory card.
The card has not been
formatted using the unit.
Replace the card.
The card may be defective.
Replace the card.
Remove the card and disable
the protect.
It is impossible to access the SD
memory card while the card is in
use. After completion of the
respective operations, perform
the write operation again.
The card is not writable because
it has no free space. Delete
unwanted files or replace the
card with a new one.