Panasonic P2HD VariCam AJ-HPX3700G Operating Instructions Manual page 139

Selecting the USER CLIP NAME recording
method
Select META DATA USER CLIP NAME from the
thumbnail menu to select the recording method. Two options
are available: TYPE1 and TYPE2.
TYPE1 (Factory setting)
If clip metadata has been read in
If no clip metadata has been read
in or if the setting for recording
clip metadata has been turned off
TYPE2
If clip metadata has been read in
If no clip metadata has been read
in or if the setting for recording
clip metadata has been turned off
* The COUNT value is indicated as a four-digit number.
The COUNT value is incremented each time a new clip is
captured if clip metadata has been read in and TYPE2 has
been selected as the recording method.
The COUNT value can be reset using the following
procedure.
Select META DATA PROPERTY from the thumbnail
menu, then select USER CLIP NAME to display the menu
shown below. Select "COUNT RESET" with the cursor and
press the SET button to reset the COUNT value to 1.
USER CLIP NAME to be
recorded
Uploaded data
Same as GLOBAL CLIP ID
(UMID data)
USER CLIP NAME to be
recorded
Uploaded data + COUNT
value*
Same as CLIP NAME
Note
When a P2 card with a memory capacity of 8 GB or more is
used in unit and a one-time continuous recording exceeds
the prescribed duration (DVCPRO HD and the AVC-
Intra100: about 5 minutes; AVC-Intra50: about 10 minutes)
or when a one-time recording extends over more than one
P2 card, the recording concerned will automatically be
undertaken as a separate clip. At this time, each clip will be
provided with its own COUNT value.
Example of recording (DVCPRO HD) a clip on one P2 card:
Recording start
Recording duration = Approx. 7 min
Clip 1
COUNT value = 0001
Approx. 5 min
Example of recording a clip on two P2 cards:
Recording start
Clip 1
COUNT value = 0003
1st card
If the clip thumbnails are displayed as shown in the example
above or their properties are indicated using a P2 device,
the thumbnail and COUNT value of clip 1 will be displayed.
Clear the uploaded metadata
Select META DATA INITIALIZE from the thumbnail menu,
and press the SET button. Select YES when the
confirmation screen is displayed.
Notes
Japanese or Chinese characters indicated in English or
other characters that cannot be indicated in English will
not display properly; they will be indicated as
The letters which can be input with the unit are only the
alphanumeric. The unit cannot input Japanese and
Chinese.
Manipulating Clips with Thumbnails: Setting of Clip Meta Data
Recording pause
Clip 2
COUNT value = 0002
Approx. 2 min
Recording pause
Clip 2
COUNT value = 0004
2nd card
.
139