Panasonic P2HD VariCam AJ-HPX3700G Operating Instructions Manual page 108

If the following messages are displayed when the jog dial
button is pressed, the data cannot be deleted.
Error message
DELETE NG
NO CARD
(No SD memory card is
inserted)
DELETE NG
ERROR
(Data cannot be deleted)
DELETE NG
WRITE PROTECT
(The SD card is write protected)
DELETE NG
CANNOT ACCESS
(It is impossible to access the
data)
DELETE NG
NO FILE
(No file is available)
7
Move the arrow (cursor) to YES by turning the jog dial
button and then press the jog dial button. When the
write operation is completed, the following message is
displayed.
108
Adjustments and Settings for Recording: Chromatic Aberration Compensation (CAC)
Measures
Insert an SD memory card.
It is assumed that the SD
memory card is defective.
Replace the card.
Eject the SD memory card and
release write protection.
It is impossible to access the SD
memory card while the card is in
use. After completion of the
respective operations, perform
the delete operation again.
Select the file No. containing
astigmatism files and perform
the delete operation.
When CAC file does not operate properly
The following error messages are displayed in the viewfinder
when CAC does not operate properly or CAC files cannot be
read properly.
Error message Meanings
FILE MEMORY When the CAC file is
FULL read from the SD
memory card to
memory in the unit in
EMPTY mode, the
built-in memory is full.
CAC FILE DATA When the CAC
NOT FOUND function is set to ON
and no CAC file
applicable to the
connected lens is
available. This is
displayed when the
power of the unit is
turned on.
CAC LENS DATA When the unit cannot
INVALID respond to the return
data from the lens, or
when any responses
other than ones as
defined in the CAC file
are returned.
LENS Initialization of the
INITIALIZE NOT lens position detection
COMPLETED (focus/zoom) in the
encoder type is not
completed yet.
Notes
When lens optical accessories (converter lens,
attachment) are installed, the CAC may not operate
properly due to changes in the optical characteristics of
the lens. In this case, turn off the CAC function.
When focus servo is used with Canon lenses, data must
be recorded after initialization in the automatic initialization
mode. The state where the focus ring is moving may be
recorded.
When the CAC does not operate and no error message is
displayed, the version of the software for the lens may be
out of date and invalid. Please contact the lens
manufacturer.
Measures
Read the CAC file in a
mode other than
EMPTY mode.
Read the CAC file that
is applicable for the
lens to be used.
This lens does not
support CAC
correction. Although it
cannot execute CAC
correction, using this
lens presents no
problems.
Turn the focus/zoom
ring to through the
intermediate point of
the operation range.