Table of Contents
Advertisement
TRENDnet User's Guide
5. The founded cameras will show on the screen. The camera already selected by default
if you have only one camera installed. If you have more than one camera in the same
Network, you will need to identify the camera by the MAC ID. Click Next.
6. Select "DHCP" option to assign an IP by DHCP server or Select "Fixed IP" to set IP
address manually. Click Next.
© Copyright 2015 TRENDnet. All Rights Reserved.
7.
If you select "Fixed IP", fill out the IP address, subnet mask, default gateway, DNS
server. Please ensure that the IP address of the camera and the computer must within
the same network. Click Next.
8.
Type in the Password. The default password is "admin". You must change the default
password of the camera. Enter the default password: admin and enter the new
password. The password must be between 8 and 16 characters. (Alphanumeric: a-z,
A-Z, 0-9), and confirm the new password by entering the password twice.
*
This camera installation wizard is also good for finding the camera if it was setup
with DHCP. The IP address may change dynamically with the DHCP setting. If you
want to access your camera later and you do not know the IP address, you can
run this camera installation wizard again. If you have already setup the password
and want to keep the password unchanged, un-check the Change Password box
and click next to get the link to access your camera.
** Please save the password for future reference. This device does not have a
hardware rest function for temper proof purpose.
TV-IP312PI
6
Advertisement
Table of Contents
