Kyocera TASKalfa 2552ci Operation Manual page 453

Setup and Registration (System Menu) > System Menu
Item
Correcting Black Lines
System Initialization
Display Brightness
Silent Mode
Memory Diagnostics
Auto Color Correction
Color Registration
Calibration Cycle
Tone Curve Adjustment
Correct fine lines (streaks caused by contamination), which may appear on the
image, when the document processor is used.
Value
Off: No correction performed.
On (Low): Correction performed. The reproduction of fine lines on the original
may become lighter than when using [Off].
On (High): Select this item if a streak remains after using [On (Low)]. The
reproduction of fine lines on the original may become lighter than when using
[On (Low)].
Initialize the hard disk installed on the machine to return it to the factory defaults.
NOTE
This function will not be displayed when the optional Data Security Kit is activated.
Set the brightness of the touch panel.
Value: 1 (Darker), 2, 3, 4, 5 (Lighter)
Set the Silent Mode. Select this mode when the running noise is uncomfortable.
Value: Off, On
NOTE
When [On] is selected, it may take time for the next print job to start.
Perform this function to check the machine memory.
This setting allows you to adjust the detection level used by the machine to determine
whether the original is color or black and white in Auto Color Selection Mode. Setting
a lower value will result in more originals being identified as color, while a larger value
will tend to increase the number of originals being identified as black and white.
Value: 1 (Color), 2, 3, 4, 5 (B & W)
When first installing the machine or moving it to a new location, color drift during
printing may occur. Use this function to correct the color position of each of cyan,
magenta and yellow to resolve color drift.
Color Registration Procedure (page 10-49)
Set the calibration cycle.
Value:
Auto: Automatically sets the cycle for calibration.
Short: Priority is given to image quality.
Standard: Balances image quality and print speed.
Long: Priority is given to print speed.
NOTE
When [Custom] is displayed as setting item, the setting cannot be changed.
After prolonged use, or from the effects of surrounding temperature or humidity, the
printed output tone may differ from the original. Perform this function to ensure
consistency with the original tone.
Tone Curve Adjustment (page 10-53)
8-73
Description