Table of Contents
Advertisement
Disassembly Procedures
!
Rear Plenum, Rear Plenum Cover and
Blower Box Top
1. Turn off power to the range.
2. Turn off and disconnect gas supply to the range.
3. Disconnect downdraft ductwork from range and
remove range from cabinet.
4. Remove maintop assembly, burner box and top
plenum.
5. Remove screws securing blower box top to motor
assembly. Allow motor assembly to rest on floor.
6. Remove screws securing rear plenum cover to rear
plenum.
7. Remove screws securing rear plenum to back of
range.
8. Reverse procedures to reassemble.
Top Plenum
1. Turn off power to the range.
2. Turn off and disconnect gas supply to the range.
3. Disconnect downdraft ductwork from range and
remove range from cabinet.
4. Remove maintop assembly and burner box.
5. Remove upper rear shield mounting screws and
carefully remove shield.
6. Remove rear wire shield mounting screws and
carefully remove shield.
7. Remove rear plenum cover mounting screws and
carefully remove cover.
8. Remove top plenum mounting screws and remove
plenum.
9. Reverse procedures to reassemble.
Fan Interlock (Bucket) Switch
1. Turn off power to the range.
2. Remove maintop assembly and burner box.
3. Remove switch mounting screws and speed nut
retainer.
4. Disconnect switch wire leads and remove switch.
5. Reverse procedures to reassemble.
Oven Light
1. Turn off power to the range.
2. Unscrew (counter clockwise) knurled glass lens and
remove it from light socket.
3. Unscrew bulb from the socket
!
CAUTION
Wear protective gloves when removing or replacing
bulb in case of bulb breakage.
4. Reverse procedures to reassemble.
NOTE: Replace with 40 watt appliance bulb only.
WARNING
Unplug power source and shut off gas suppl before servicing,
unless testing requires it.
Oven Light Socket
1. Turn off power to the range.
2. Turn off and disconnect gas supply to the range.
3. Disconnect downdraft ductwork and remove range
from cabinet.
4. Unscrew oven light lens and remove light bulb.
5. Remove upper rear shield mounting screws and
remove shield.
6. Remove rear wire shield mounting screws and
remove shield.
7. Depress light socket retaining tabs to release socket
from oven tank and push socket assembly partially
into oven cavity.
8. Disconnect socket wire leads and remove socket.
9. Reverse procedures to reassemble.
Oven Light Assembly
Side Panel Trim
1. Turn off power to the range.
2. Turn off and disconnect gas supply to the range.
3. Disconnect downdraft ductwork and partially remove
range from cabinet.
4. Remove maintop assembly and partially remove
control panel.
5. Remove side panel trim mounting screws and
carefully slide trim off of the side panel.
6. Reverse procedures to reassemble.
51
RS2310003 Rev. 0
Advertisement
Table of Contents
