Pressure Regulator Location; Gas Supply Location; Gas Supply Pressure; Gas Connection - Amana AGDS901 Service Manual

Gas self-clean downdraft ranges
Hide thumbs Also See for AGDS901:
Table of Contents

Advertisement

Installation Instructions

Pressure Regulator Location

11"
8 1/4"

Gas Supply Location

Gas supply must be located in the shaded area shown
below. Gas connection must not interfere with the
electrical connection.
2"
4"
6"

Gas Supply Pressure

!
WARNING
To avoid property damage, maximum gas supply
pressure must not exceed 14" WCP.
• The appliance and its individual shut-off valve must be
disconnected from the gas supply piping system
during any pressure testing of that system at test
pressures in excess of ½ psig (3.5kPa)
(14" WCP).
• The appliance must be isolated from gas supply piping
system by closing its individual manual shut-off valve
during any pressure testing of the gas supply piping
system at test pressures equal to or less than ½ psig
(3.5kPa) (14" WCP).
• Gas supply pressure for checking regulator setting
must be at least 1" WCP above manifold pressure
shown on rating label.
RS2310003 Rev. 1
8 1/4"
2"
2"

Gas Connection

Connect gas supply to regulator using hard pipe or a
flexible connector. Pressure regulator supplied with this
appliance has a ½ inch NPT female connection. See
figure below.
• A manual shut-off, not supplied with range, must be
installed in an accessible location outside of range.
• Use joint compound that is resistant to action of
propane gas on all male pipe threads.
• Use supplied pressure regulator only.
• Do not over tighten regulator when attaching to gas
manifold pipe or hardpipe. Overtightening may crack
regulator.
!
To avoid property damage or personal injury, only use
a new flexible connector that is AGA design certified.
• Do not use an old connector.
• Do not reuse a connector after moving
appliance.
• Do not overtighten regulator connector fitting.
12
WARNING

Advertisement

Table of Contents
loading

Table of Contents