Oven Light Bulb; Stainless Steel Areas; To Replace Light Bulb - Jenn-Air SVD8310S Use And Care Manual

Stainless Steel Areas
• TO clean light soil, wipe with soapy cloth or nonabrasive cleanser, such as Soft
Scrub. Rinse, buff with soft cloth; polish with glass cleaner if necessary.
• To clean moderate soil or discoloration of the surface (excessive heat will cause a
golden discoloration), clean with Zud, Bar Keepers Fdend, or Luneta (Jenn-Air
Model A912, Part No. 712191). With a sponge or cloth, rub cleanser with the grain
to avoid streaking the surface. Rinse well, buff dry; polish with a glass cleaner if
necessary to removecleanser residue and smudge marks.
• Heavy soil, such as burned on food soil, can be removed by first cleaning as per the
instructions for moderate soil. Stubborn stains can be removed with a damp
Scotch-Brite scour-pad; rub evenly with the grain to avoid streaking the surface.
Rinse well, buff with dry cloth; polish with glass cleaner if necessary to remove
cleanser residue and smudge marks. Scotch-Bdte is also useful in buffing and
removing minor scratches.
Beforereplacingbulb,disconnect power to oven at the main fuse or circuit breaker panel
andat the electdcreceptacle.Be surethat the entireoven cavityincluding the lightbulb
is coolbefore attemptingto remove.
To replace light bulb " " '__ _ _ J _.
1. Carefullyremovethe glass lightlens and lens retainerby _
removing the two screwsin the lightlens retainerusinga
phillips screwdriver, Note: The lightlens isseparatefrom
the lightlens retainer, The two pieceswilldrop downinto
your hands at the same time, Do NOT remove the
remaining two screws.
2. To obtain firm grasp on bulb, wear protective rubber
gloves. Remove by turning bulb to the left. Do not touch
a hot oven light bulb with a damp cloth as bulb will break.
Note: If the bulb does break and you wish to remove it, be I \\ \\ I
certain power supply is disconnected and wear protective
gloves. You may contact your authorized Jenn-Air Service
Contractor for service.
3. Replace bulb with a 40 watt oven-rated appliance bulb.
Bulb with brass base is recommended to prevent fusing of
bulb into socket.
4. Place light lens inside of light lens retainer. Holding the
light lens and lens retainer in place, insert the two screws
into the light lens retainer and tighten.
45