To Replace Light Bulb - Jenn-Air PRG3010 User Manual

1
f
Stubborn soils - scrub with scouring
powder. (Do not use abrasive cleaners,
scouring pads or place in a serf-dean
oven.) If cleaningpowders Nod<gasports
on burner ring, dean with a straight pin.
To replace parts after cleaning:
[) ported burner ring- align the slot on
the bottom of the ring with the locat-
ing post on the burner base.The
burner ring and burner basemust be
in complete contact.
2) burner cap - place on top of the
burner tube.
SURFACE BURNER _GNITORS
° Clean around ignitor carefully. Avoid
catchingthe ignitor with cleaningcloth. If
ignitor is damaged, the surface burner
wi[[ NOT light.
SURFACE BURNER GRATES
(PORCELAIN ON CAST IRON 1
• Wash in the dishwasher or in soap and
water with a plastic scrubber.
• Do not operate the burners without a
panon the grate. The porcdain finish on
the grate may chip without a pan to
absorb the intense heat.
° Grates wi[[ become du[[ and may discolor
over time from the heat. This is normal
OVEN DOOR
. NEVER place excessive weighton or
stand on an open oven door. This
could cause the range to up over,
break the door. or injure the user,
• NEVER attempt to open or dose
door or operate oven until door is
proper[), replaced.
ffthe oven door comes off track, realign by
following this simple procedure:
[. Open the door and hold it a[[ the way
open.
2. Lod< the hinge latches (see illustration),
and gendy lift the door up and partially
out until the door is evenly aligned.
3. Evenly slide the door back into place and
check m
be
sure the
hinges rest in
the
center of each door hinge rd[er.
4. With the oven door fully open, unlock
hinge latches and dose.
Door Hinge Roller
Lock
(Close)
Un{ock
Before replacing bulk disconnect
powerto
oven at the main fuse or circuit breaker panel.
Be sure that the oven cavity, including the
light bulb, is coo[.
TO REPLACE LIGHT BULB:
lo
2.
Carefully unscrew
the glass bulb cover.
To obtain firm grasp
on bulb, wear pro-
tective rubber
gloves. Turn bulb to
the left. Do not
touch a hot oven bulb with a damp cloth
as it wi[[ break.
Note: tf the bulb breaks, be certain
3_
,
power supply is disconnected and
wear protect#re gloves when remov-
#rig. Contact an authorized ]enn-A#r
Servicer, if needed.
Replacebulb with a 40 watt oven-rated
appliance bulb. Bulb with brass base is
recommended.
Replace bulb cover and reconnect power
tO oven,
( ..... ,)F GAS REN ,)VAL ( ,
Gas applianceconnectors usedm connect
this appliance m the gas supply are not
designedfor continuous movement. Once
installed, DO NOT repeated[),move this
gasappliancefor cleaning or to relocate. If
this appliance has to be moved and/or
removed for servicing, follow the proce-
dure described in the installation instruc-
tions. For information, contact Jenn-Air
Customer Service at 1-800-JENNAJR
(I-800-536-6247).
To prevent rangefrom accidentally tipping,
range must be secured to the floor by
sliding rear leveling leg into the anti-tip
bracket.
J3