Table of Contents
Advertisement
Oven
Care
Oven
Cleaning
The oven porcelain
walls and door can be wiped clean with soap and water if food
is not allowed to bake on a second time. Heavy spattering
of spillovers
will require
cleaning
with mild abrasive cleansers
such as Bar Keepers Friend, S.O.S. or Bon
Ami. Household
ammonia
may be used to loosen soil by placing
T/_ cup household
ammonia in a glass dish placed on oven rack in a closed, cold oven overnight.
• To remove difficult
stains, use an oven cleaner such as Easy-Off on oven liner.
Follow oven cleaner directions.
Do not spray electrical
controls,
temperature
sensing
bulb, door gasket or exterior
of oven. Remove oven racks and rack
supports before spraying with oven cleaner.
• For cleaning other areas of the oven, clean oven racks with S.O.S. pads. Oven
window may be cleaned with soap and water or a glass cleaner.
Oven
Light
Bulb
Before replacing
bulb, disconnect
power to oven at the main fuse or circuit breaker
panel. Be sure that the entire oven cavity including
the light bulb is cool before
attempting
to remove.
To replace
light
I..11):
1. Carefully
remove the glass light lens and lens
retainer
by removing the two screws in the light
lens retainer using a phillips screwdriver. Note: The
light lens is separate from the light lens retainer.
The two pieces will drop down into your hands at
the same time. Do NOT remove the remaining two
screws.
2. To obtain firm grasp on bulb, wear protective
rubber gloves. Remove by turning bulb to the left.
Do not touch a hot oven light bulb with a damp
cloth as bulb will break. Note: If the bulb does
break and you wish to remove it, be certain power
supply isdisconnected and wear protective gloves.
You may contact your authorized Jenn-Air Service
Contractor for service.
3. Replace bulb with a 40 watt oven-rated
appliance
bulb. Bulb with brass base is recommended
to
prevent fusing of bulb into socket,
4. Place light lens inside of light lens retainer. Hold-
ing the light lens and lens retainer in place, insert
the two screws into the light lens retainer and
tighten.
26
Advertisement
Table of Contents
