Electronic Control; Transformer; Oven Light Bulb/Oven Light Socket; Oven Light Switch - Jenn-Air JGS8750ADB Service Manual

Disassembly Procedures

Electronic Control

1. Remove control panel, see "Control Panel"
procedure, steps 1 through 4.
2. Remove screws securing electronic control bracket to
control panel.
3. Label and disconnect terminal wiring from electronic
control.
4. Reverse procedure to reinstall electronic control.

Transformer

1. Remove power from unit.
2. Remove back panel, see "Back Panel" procedure.
3. Label and disconnect wire terminals from cooling fan.
4. Remove screws securing fan to range chassis.
5. Reverse procedure to reinstall cooling fan.
Broil Element

Oven Light Bulb/Oven Light Socket

NOTE: Requires removal of unit to replace oven light
socket.
The light automatically comes on when the door is
opened. The light will not operate during a clean cycle.
1. Remove power from unit.
2. Open oven door and locate oven light.
3. Grasp lens cover and pull outward on one side to
gain access to bulb.
4. Carefully remove old bulb, by lifting bulb straight out
of ceramic base.
24
Electronic
Control
Control
Panel

Oven Sensor

Cooling
Fan
Transformer
Meat
Probe
16022089
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas before servicing.
NOTE: To avoid damaging the new bulb and
decreasing life of the bulb, do not touch new
bulb with bare hands or fingers.
Hold with a cloth or paper towel.
NOTE: Proceed with the following steps for oven light
socket removal.
5. Remove unit from installation position, see
"Removing and Replacing Range" procedure.
6. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
7. Carefully displace fiberglass insulation away from
rear of light socket.
8. Release metal tabs on light socket and push socket
assembly away from the oven cavity.
9. Label and disconnect wires from light socket.
10.Reverse procedure to reinstall light socket.
Reposition insulation around lamp socket.
NOTE: Reposition fiberglass insulation around light
socket to eliminate the possibility of any heat
related problems.
Bulb
Lens
Bulb specifications
G5.3 Type Halogen Bi-Pin 25W-120V

Oven Light Switch

1. Remove power from unit.
2. Remove control panel, see "Control Panel"
procedure.
3. Remove screws securing oven light switch to front of
oven chassis.
4. Reverse procedure to reinstall oven light switch.
Oven Sensor
1. Remove power from unit.
2. Open oven door and remove screws securing sensor
to oven cavity.
NOTE: Gently pull wiring through cavity wall.
3. Disconnect oven sensor at the connector terminal
and remove.
4. Reverse procedure to reinstall sensor.
NOTE: Verify sensor wires are pushed through the
insulation.
Socket
©2005 Maytag Services