Advertisement
Plug-In Surface Units
~
Clean the area under the drip pans
often. Built-up soil, especially
grease, may catch fire.
To make cleaning easier, the plug-
in surface units are removable.
Lift a plug-in unit about 1" above the
trim ring—just enough to grasp it—
and you can pull it out.
Do not lift a piug-in unit more
than 1!'If you do, it may not lie
flat on the trim ring when you
plug it back in.
..
Repeated lifting of the plug-in
unit more than 1" above the trim
ring can permanently
damage
the receptacle.
Caution: Be sure all controls are
turned to OFF and surface units
are cool before attempting to
remove them.
After removing a plug-in unit,
remove the drip pan/ring under the
unit and clean it according to
directions in the Cleaning Guide on
page 35. Wipe around the edges of
the surface unit opening. Clean the
area below the unit. Rinse all
washed areas with a damp cloth
or sponge.
(
Receptacle
Drip Pan/Ring
To replace a plug-in unit:
Place the drip pan/ring into the
surface unit cavity found on top of
the cooktop so the unit receptacle
can be seen through the opening in
the pan.
Insert the terminals of the plug-in
unit through the opening in the drip
pan and into the receptacle.
Guide the surface unit into place
so it fits evenly into the trim ring.
CAUTION
Do not attempt to clean plug-in
surface units, plug-in griddle or
grill heating units in an automatic
dishwasher.
Do not immerse plug-in surface
units in liquids of any kind.
Do not bend the plug-in surface
unit plug terminals.
Do not attempt to clean, adjust
or in any way repair the plug-in
receptacle.
AdjWing Oven Thermostat
Use time given on recipe when
cooking fmt time. Oven thermostats,
in time, may "drift" from the
factory setting and differences in
timing between an old and a new
oven of 5 to 10 minutes are not
unusual. Your oven has been set
correctly at the factory and is more
apt to be accurate than the oven
which it replaced. However, if you
find that your foods consistently
brown too little or too much, you
may make a simple adjustment in
the thermostat (Oven Temp) knob.
PULL KNOB OFF OF SHAFT,
LOOK AT BACK OF KNOB AND
NCYI'ECURRENT
SETTING,
BEFORE MAKING ANY
ADJUSTMENT.
To increase temperature,
turn
toward HI; to decrease turn toward
LO. Each notch changes temperature
10 degrees.
?O adjust oven thermostat:
1.
Pull off knob. Loosen both
screws on back of knob.
2. Move pointer one notch in
desired direction. Tighten screws.
3. Return knob to range, matching
flat area of knob to shaft.
Recheck oven performance before
making an additional adjustment.
#
6'
33
Advertisement
