Selecting Front Panel Lock Mode 2 Or Toggling Between Lock Modes 2 And 1 - Extron electronics DXP HD 4K Series Setup Manual

Selecting Front Panel Lock Mode 2 or Toggling between
Lock Modes 2 and 1
NOTES:
Toggle the lock on and off by pressing and holding the Video
and Audio buttons until the following buttons blink twice
(approximately 3 seconds).
•
•
DXP 44, 84, and 88
Press and hold
simultaneously.
3 seconds
I/O
The LEDs blink twice.
Release the buttons.
Figure 23.
NOTE:
24 DXP HD 4K Series • Operation
• If the switcher is in lock mode 1, this procedure selects
mode 2.
• If the switcher is in lock mode 2, this selects mode 1 (locks
all switcher functions except selecting mode 2).
If the DXP is now in lock mode 2, the Esc, Video, and Audio
buttons or LEDs blink twice.
If the DXP is now in lock mode 1, the Video and Audio
buttons or LEDs blink twice.
ESC I/O
VIDEO
AUDIO
Press and Hold the Two I/O Buttons Simultaneously
To switch from lock mode 1 (front panel is completely
locked) to lock mode 0 (front panel is unlocked), you must
first switch to mode 2, then from mode 2 to mode 0.
DXP 168 and 1616
Press and hold
simultaneously.
I / O
VIDEO
AUDIO
2 seconds
I / O
VIDEO AUDIO
The buttons blink twice.
Release the buttons.