Viewing Ties - Extron electronics DXP HD 4K Series Setup Manual

Viewing Ties

Several methods are available for viewing which inputs and
outputs are actively connected (tie configuration) and which
outputs are muted, at the same time.
NOTE:
Esc button to clear any pending ties.
DXP 44, 84, and 88
For the I/O button, the Video selection routes HDMI signals from
any of the inputs to any of the HDMI outputs. The Audio selection
routes the de-embedded audio from any of the HDMI inputs to any
pair of S/PDIF and analog audio outputs.
NOTE:
with the same number and cannot be selected separately,
although they can be individually muted. Any de-embedded
audio signal sent from an input goes to both the S/PDIF and
analog output with which it is paired.
To view existing ties:
1. Press the I/O button to select audio or video (selection of both
simultaneously is not supported on these models).
2. Select the input or output ties to view:
•
•
•
To turn off all lit LEDs, press the Esc button, or wait until the lit
3.
button LEDs time out (approximately 15 seconds).
Before beginning to view ties and mutes, press the
Each S/PDIF output is paired with the analog output
To view ties to an input: Press the desired input button.
The button LEDs light for all outputs that are tied to that
input (green for video ties or red for audio ties).
NOTE: If you press an output button while an input is
selected for viewing, the output LED blinks to indicate
a pending tie. Press Esc to cancel the tie or Enter to
add the tie to the selected input.
To view ties to an output: Press the desired output
button. The buttons LEDs for the tied input and all other
outputs tied to that input light.
To view all untied outputs: Press an untied output button
while another output is selected. All untied output LEDs
light.
DXP HD 4K Series • Operation 25