Extron electronics DXP HD 4K Series Setup Manual page 23

Secondary:
Select the baud rate for the Remote RS-232 port.
•
Set the front panel lock mode.
•
The Esc
NOTE:
configuration or any presets.
I/O buttons —
E
DXP 44, 84, and 88 — These models have one I/O
•
button with two LEDs to its right: a green Video LED and
a red Audio LED. Press the I/O button to toggle between
video (green LED lights) and audio (the red LED lights).
DXP 168 and 1616 — These models have two I/O
•
buttons: Video and Audio. The Video button lights green
to indicate that video is available for configuring or for
viewing. The Audio button lights red to indicate that audio
is available.
These buttons have the following functions:
Primary:
Select the signal type, audio or video, for the input or
•
output.
Select audio or video for the configuration that is being
•
viewed.
Secondary:
Select the baud rate for the Remote RS-232 port.
•
Set the front panel lock mode (executive mode).
•
View the video or audio mute status of the selected input or
•
output.
Audio and Video LEDs (DXP 44, 84, and 88 only) — These
F
two LEDs are located to the right of the I/O button and light to
indicate whether the selected input or output is audio or video.
The Video LED lights green when the I/O button is pressed
to toggle to video. The Audio LED lights red when audio is
selected.
Signal LEDs (DXP 44, 84, and 88 only) — The DXP 44, 84,
G
and 88 models have a green Signal LED for each input. Each
LED lights when a signal (TMDS clock activity) is present on the
input.
H HDCP LEDs (DXP 44, 84, and 88 only) — The DXP 44, 84, and
88 models have a green HDCP LED for each input, which lights
if the source connected to that input is HDCP encrypted.
>
button does not reset the current
DXP HD 4K Series • Operation 17