Setup; Setup Steps - Extron electronics DXP HD 4K Series Setup Manual

Setup

This section describes the rear panels of the DXP HD 4K switchers
and provides instructions for cabling. It covers the following topics:

Setup Steps

•
Rear Panels and Connections
•
• Securing HDMI Cables with the LockIt HDMI Cable Lacing
Bracket
Front Panel Config Port
•
Setup Steps
Follow these steps to set up and start operating the DXP switcher.
See the
procedures you may want to perform to set up the DXP.
1. Turn off power to the input and output devices that will be
connected and disconnect their power cords.
2. Connect HDMI input devices to the rear panel input connectors
(see
3. Connect HDMI audio and video output devices to the rear panel
output connectors (see
4. (Optional, DXP 1616 Series only) Change any required button
labels (see "Making Labels Using the Button-Label Generator
Program — DXP 1616 Series Only" in the DXP HD 4K User
Guide).
5. If desired, connect a computer or control system to the Remote
RS-232 control port (see
panel USB Config port (see
6. If desired, connect a network switch, a control system, or a
computer to the RJ-45 LAN port (see
7. Plug the DXP switcher into a grounded AC source, and connect
power to the input and output devices.
8. Download the Extron Product Configuration Software (PCS)
from www.extron.com.
9. Select EDID files to apply to inputs as desired, using SIS
commands or the PCS configuration software. See
(Extended Display Identification Data)
configuration program help file and the DXP HD 4K Series User
Guide for details.
10. Create ties and presets as desired (see
page 18 or
Operation
section, beginning on page 13, for additional
figures 3 and 4,
A
Saving or Recalling a Preset
, on the next page).
figures 3 and 4,
B
figures 3 and 4,
E
figures 10 and
figures 3 and
on page 31, or see the
Creating a Tie
on page 20).
DXP HD 4K Series • Setup
).
) or to the front
11, , on page 14).
E
4, ).
F
EDID
on
5