Extron electronics DXP HD 4K Series Setup Manual page 14

•
For more details on these reset modes, see the
DXP HD 4K User Guide, available at www.extron.com.
Remote connector — Connect an RS-232 capable host
E
device such as a computer or a touch panel control to this
3.5 mm 3-pole captive screw connector to configure and
control the switcher via SIS commands.
Connect the 9-pin connector end of the RS-232 cable to the
serial port of your computer or control system.
Figure 5.
See
basic SIS commands to set up the DXP.
F LAN port — Connect a computer, a network switch, or a
control system to this RJ-45 connector. With the Ethernet
connection, you can use a computer to configure and control
the networked switcher with SIS commands, the PCS
configuration program, or the embedded HTML page.
8 DXP HD 4K Series • Setup
Absolute reset (mode 5) — While the DXP is running,
press and hold the Reset button until the LED blinks three
times (approximately 9 seconds). Release the button and
press it again momentarily to restore the switcher to the
default factory conditions.
Wiring the Remote RS-232 Connector
SIS Commands on page 30 for definitions of some of the