Battery; Maintenance Instructions - BMW HP4 Rider's Manual

Hide thumbs Also See for HP4:
Table of Contents

Advertisement

charged battery and the other
9
end to the positive terminal of
the donor battery.
160
Then connect one end of the
black jump lead to the negative
terminal of the donor battery,
and the other end to the neg-
ative terminal of the discharged

battery.

Start the engine of the vehicle
with the discharged battery
in the usual way; if the en-
gine does not start, wait a few
minutes before repeating the
z
attempt in order to protect the
starter motor and the donor
battery.
Allow both engines to idle for a
few minutes before disconnect-
ing the jump leads.
Disconnect the jump lead from
the negative terminals first,
then disconnect the second
lead from the positive termin-
als.
Installing front seat (
Battery

Maintenance instructions

Correct upkeep, recharging and
storage will prolong the life of
the battery and are essential if
warranty claims are to be con-
sidered.
Compliance with the points be-
low is important in order to max-
imise battery life:
Keep the surface of the battery
clean and dry.
Do not open the battery.
Do not top up with water.
Be sure to read and comply
with the instructions for char-
ging the battery on the follow-
ing pages.
Do not turn the battery upside
down.
If the battery is not discon-
nected, the on-board elec-
tronics (e.g. clock, etc.) gradually
drain the battery. This can cause
57).
the battery to run flat. If this hap-
pens, warranty claims will not be
accepted.
Connect a float charger to the
battery if the motorcycle is to
remain out of use for more than
four weeks.
BMW Motorrad has de-
veloped a float charger spe-
cially designed for compatibility
with the electronics of your mo-
torcycle. Using this charger, you
can keep the battery charged
during long periods of disuse,
without having to disconnect the
battery from the motorcycle's
on-board systems. You can ob-
tain additional information from
your authorised BMW Motorrad
dealer.
Disconnecting battery
from motorcycle
Make sure the ground is level
and firm and place the motor-
cycle on its stand.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents