Electrical Connection - Miele DGD 4635 Operating And Installation Instructions

Electrical connection


Danger of injury!
Incorrect installation, maintenance or
repair work is dangerous to users.
Miele cannot be held liable for dam‐
age or injury caused by incorrect in‐
stallation, maintenance or repair
work, or by an inadequate or faulty
earthing system (e.g. electric shock).
All electrical work should be carried
out by a suitably qualified and com‐
petent person, in strict accordance
with current national and local safety
regulations.
After installation, ensure that all elec‐
trical components are shielded and
cannot be accessed by users.
100
Total power output
See data plate.
Connection
AC 230 V, 50 Hz
The voltage and rated load are given on
the data plate. Please ensure these
match the household mains supply.
Please see the wiring diagram for con‐
nection.
Connection should be made via a suita‐
ble isolator which complies with nation‐
al and local safety regulations, and the
On/Off switch should be easily accessi‐
ble after the appliance has been built in.
Residual current device
For extra safety, it is advisable to install
a residual current device (RCD), with a
trip current of 30 mA.
Disconnecting devices
The appliance must be able to be dis‐
connected from the mains on all poles
by disconnecting devices. When
switched off there must be an all-pole
contact gap of at least 3 mm in the iso‐
lator switch.