Overheating Protection - Miele DGD 4635 Operating And Installation Instructions

Overheating protection

The overheating protection device is lo‐
cated underneath the On/Off switch.
This switches the heating off automati‐
cally if the temperature in the steam
generator gets too high.  will appear
in the function / temperature display
and the cooling down phase will start.
The cooling down phase lasts for 1 mi‐
nute. There will be several beeps when
it is finished.  will then flash in the
function / temperature display for a
short while and then three horizontal
bars - - - will appear. A short while later
 will appear in the display.
 Switch the appliance off and open
the door.
 Allow the appliance to cool down for
approx. 30 minutes.
 will disappear from the display
whilst the appliance is cooling down.
 Remove the protective cap from the
overheating protection device (see
arrow). Use a screwdriver or similar
thin tool to press the device in again.
 Replace the cap.
The steam oven can now be used again
as normal.
If the overheating protection device
trips again, contact Miele.
Safety features
29