Table of Contents
Advertisement
Troubleshooting
3
Remove the extra printer hard disks.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many flash options installed [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many trays attached [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra trays.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Tray [x] paper size unsupported
Replace with a supported paper size.
Unformatted flash detected [53]
Try one or more of the following:
•
From the scanner control panel, touch Continue to stop the defragmentation and continue printing.
•
Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and needs to be replaced.
Unsupported camera mode, unplug camera and change mode
The camera mode does not support PictBridge.
Unplug the camera, change the mode and plug the camera back into the printer.
Unsupported disk
An unsupported disk has been inserted. Remove the unsupported disk, and then install a supported one.
313
Advertisement
Table of Contents
