Yamaha SXV70SJ Supplementary Service Manual page 96

Frame directly attached clamp
1
Clamp so that the oil tank cap
2
and oil tank breather hose do not
interfere with each other.
Band them beside the instru-
ment panel attaching bolt.
Lay the fuel tank breather hose
3
along the steering gate.
Lay the oil tank breather hose
4
along the steering gate.
Tail / brake light lead should not
5
interfere with the frame edge.
Hide the tail / brake light lead
6
coupler in the inner panel.
Route the tail / brake light lead in
front of the frame clamp.
Frame clamp
7
Pass the tail / brake light lead
8
through the inner side of the
clamp.
Make sure to pass the tail / brake
9
light lead so that it cannot be
caught between the fuel tank
and panel. Secure it to the
groove section of the fuel tank's
bottom face with an adhesive
tape at 3 places.
50 mm (1.97 in)
10
To tail / brake light unit
11
Adhesive tape
12
Pass the fuel tank breather hose
13
through holder.
Fuel sender coupler
14
Body ground lead
15
Attach the clip with its pawl di-
16
rected downward.
Install the fuel tank breather
17
hose to the end.
Compression spring
18
CABLE ROUTING
–90–
SPEC