Throttle Override System (T.o.r.s.) Check - Yamaha SXV70SJ Supplementary Service Manual

Hide thumbs Also See for SXV70SJ:

Table of Contents

THROTTLE CABLE FREE PLAY ADJUSTMENT/

THROTTLE OVERRIDE SYSTEM (T.O.R.S.) CHECK

Throttle cable free play

Adjustment steps:

Loosen the locknut 1.

Turn the adjusting nut 2 in or out until the

specified free play is obtained.

Turning in → Free play is increased.

Turning out → Free play is decreased.

Tighten the locknut.

After adjusting the free play, turn the handlebar to

right and left, and make sure that the engine idling

does not run faster.

THROTTLE OVERRIDE SYSTEM (T.O.R.S.)

When checking T.O.R.S.:

Be sure the parking brake is applied.

Be sure the throttle lever moves smoothly.

Do not run the engine up to the clutch engage-

ment speed. Otherwise, the machine could start

moving forward unexpectedly, which could

cause an accident.

1. Start the engine.

2. Hold the pivot point of the throttle lever away from

the throttle switch by putting your thumb (above)

and forefinger (below) between the throttle lever

pivot 1 and stop switch housing 2.

While holding as described above, press the

throttle lever 3 gradually.

The T.O.R.S. will operate and the engine should

run between 2,800 and 3,000 r/min.

If the engine does not run between 2,800 and

3,000 r/min, stop the engine by turning the main

switch to the "OFF" position and check the elec-

trical system.

Table of Contents