Table of Contents
Advertisement
Storage
Storage Safety
•
Shut off the machine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
Storing the Machine
Service Interval: Every 200 hours—Inspect the
service and parking brakes.
Every 400 hours—Visually inspect the brakes
for worn brake shoes.
After the first 50 hours
Every 600 hours/Yearly (whichever comes first)
1.
Position the machine on a level surface, engage
the parking brake, shut off the engine, and
remove the key.
2.
Clean dirt and grime from the entire machine,
including the outside of the engine.
3.
Inspect the brakes; refer to
Brake (page
52).
4.
Service the air cleaner; refer to
Cleaner (page
39).
5.
Seal the air-cleaner inlet and the exhaust outlet
with weatherproof tape.
6.
Grease the machine; refer to
Bearings and Bushings (page
7.
Change the engine oil; refer to
Engine Oil and Filter (page
8.
Flush the fuel tank with fresh, clean fuel.
9.
Secure all fuel system fittings.
10.
Check the tire pressure; refer to
Tire Pressure (page
11.
Check anti freeze protection and add a 50/50
solution of water and anti freeze as needed for
expected minimum temperature in your area.
12.
Remove the battery from the chassis, check
the electrolyte level, and charge it fully; refer to
Servicing the Battery (page
Note:
Do not connect the battery cables to the
battery posts during storage.
Important:
The battery must be fully
charged to prevent it from freezing and being
Adjusting the Parking
Servicing the Air
Greasing the
37).
Changing the
41).
Checking the
20).
45).
damaged at temperatures below 0°C (32°F).
A fully charged battery maintains its charge
for about 50 days at temperatures lower
than 4°C (40°F). If the temperatures will be
above 4°C (40°F), check the water level in the
battery and charge it every 30 days.
13.
Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
14.
Paint all scratched or bare metal surfaces.
Note:
Paint is available from your Authorized
Service Dealer.
15.
Store the machine in a clean, dry garage or
storage area.
16.
Cover the machine to protect it and keep it clean.
63
Advertisement
Table of Contents
