Jet Holder Removal; Side Trim And Side Panel Removal (Right Side Shown) - Viking RDSCG230-5B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Jet Holder Removal

Gas leak hazard. To avoid risk of personal injury
or death, leak testing of the appliance must
be conducted according to the manufacturer's
instructions. Before placing appliance in operation,
always check for gas leaks with soapy water solution.
DO NOT USE AN OPEN FLAME TO CHECK FOR
GAS LEAKS.
1. Shut off main gas supply to the range.
2. Remove main top (see Main Top Removal).
3. Remove clip and igniter from jet holder.
4. Loosen and slide tubing nut away from jet holder.
5. Remove inverted screws from jet holder.
6. Lift jet holder to remove from tubing.
7. Reverse procedure for installation.
8. Perform gas leak test.
©2012 Viking Preferred Service
Side Trim and Side Panel Removal
(Right side shown)
1. Remove the control panel assembly (see Control
Panel Assembly Removal).
2. Remove backguard assembly (see Backguard
Assembly Removal).
3. Remove screws and lift kick plate from keyhole
screws.
4. Remove screws and side trim from range.
5. Remove keyhole screw from front of range.
6. Remove screw from back of range.
7. Remove screws, main top support, and side panel
from range.
8. Reverse procedure for installation.
Disassembly
29