Lubrication; Greasing Bearings And Bushings - Toro Workman HD 07369 Operator's Manual

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 100 hours (Lubricate more
frequently in heavy duty applications)
The vehicle has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease.
The grease fitting locations and quantities are as follows:
• Ball joints (4), tie rods (2), pivot mounts (2) and
steering cylinder (2) (Figure 31)
• Spring tower (2) (Figure 32)
• Clutch (1), accelerator (1), brake (1) (Figure 33)
• U-joint (18) (Figure 34)
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes
out of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
Figure 31
36
Figure 32
Figure 33
Figure 34