Cooling System Maintenance; Removing Debris From The Engine Cooling System; Brake Maintenance; Adjusting The Parking Brake - Toro Workman HD 07369 Operator's Manual

Cooling System
Maintenance
Removing Debris from the
Engine Cooling System
Service Interval: Every 100 hours (Clean more
frequently in dirty conditions.)
To ensure proper cooling, clean the blower housing and
other cooling shrouds and clean the cooling fins and
external surfaces.
Note: Operating the engine with dirty or plugged
cooling fins or with the cooling shrouds removed, will
cause engine damage due to overheating.

Brake Maintenance

Adjusting the Parking Brake

Service Interval: After the first 10 hours
Every 200 hours
1. Remove the rubber grip from the parking brake lever
(Figure 49).
1. Parking brake lever
2. Loosen the set screw securing the knob to the
parking brake lever (Figure 50).
3. Rotate the knob until a force of 45 to 50 lb (20 to 22
kg) is required to actuate the lever.
1. Parking brake lever
2. Knob
4. Tighten the set screw when finished.
Note: If no adjustment is left at the handle, loosen
the handle to the middle of the adjustment and
adjust the cable at the rear, then repeat step 3.
5. Install the rubber grip onto the parking brake lever.
43
Figure 49
2. Grip
Figure 50
3. Set screw